炮掘岩巷大块矸石成因分析及防治措施

为了解决辛置煤矿东四延伸皮带巷掘进过程中由于大矸产生率过高造成巷道掘进效率低下的问题,在对大矸产生原因进行分析的基础上,提出采用锲直复合掏槽爆破方式代替原有的直眼掏槽爆破,并从巷道掘进效率、大矸产生率等方面进行详细对比分析。掘进采用锲直复合掏槽爆破方式后,大矸产生率从30%以上降低到20%以内,且最大矸石粒径从1000 mm×800 mm降低到500 mm×400 mm,巷道掘进进尺从1.5 m/d提升至3 m/d,应用效果显著。     

抽采孔液态CO2预裂效果显微CT实验研究

为研究液态CO2预裂爆破后,煤体内裂隙发育情况,采用高精度微焦点显微CT系统,对预裂后不同区域的煤样进行CT扫描,并利用Photoshop进行孔裂隙占比统计学分析。研究结果显示,距预裂孔4 m处的煤体裂隙发育明显,孔裂隙占比增加了一倍,而在5 m处的煤体裂隙则发育较弱。表明抽采孔内采取液态C2预裂技术后,4 m范围内的煤体裂隙得到了充分发育,为瓦斯抽采提供了有利条件。     

钢轨交流闪光焊接过程过梁爆破特征分析

以高速摄影技术作为主要研究手段，研究钢轨交流闪光焊接过程过梁爆破特征，并结合热成像系统采集焊接过程温度场，以此为数据基础定量分析了钢轨交流闪光焊接过梁爆破特征. 结果表明,钢轨交流脉动闪光焊接工艺模式下，加速闪光阶段具有几个阶段中最高的闪光频次46.93次/s，脉动闪光阶段具有最低的闪光频次11.07次/s；连续闪光阶段闪光烈度为0.009 2 mm/次，是几个阶段中最强的，脉动阶段的闪光烈度最弱，为0.003 8 mm/次；从闪光加热因子来看，脉动阶段最高，符合了该阶段积累热量的主要目的；加速闪光阶段最低，是由于该阶段为了制造保护气氛产生的气化过梁带走了较多的热量；从闪光均匀度看，闪光最不均匀的阶段是闪平阶段，最均匀的阶段是脉动阶段，这恰恰说明了两待焊端面的微观平行情况在闪平阶段最差、脉动阶段最佳.     

A simple and effective design strategy to increase power conversion efficiency of linear charge pumps

This paper introduces a simple design strategy to increase the power efficiency of linear charge pumps. The technique exploits a voltage amplitude of the clock signal lower than the supply voltage to reduce the power conversion losses. The nominal output voltage is maintained unaltered by increasing the number of stages.     

Inhibition effect of swelling characteristics of expansive soil using cohesive non-swelling soil layer under unidirectional seepage

Cohesive non-swelling soil (CNS) cushion technology is widely used to solve swelling deformation problems in expansive soil areas. However, the swelling inhibition mechanism is still not fully understood. In this study, the inhibition effect on expansive soil using a CNS layer was studied by performing five types of laboratory model tests under unidirectional seepage. The results showed that CNS cushion technology produced a sound inhibition effect on the swelling characteristics of expansive soil. It was shown that the cations in the CNS layer moved downward and accumulated on the surface of solids and produced an electrical environment inside the expansive soil. In this process, the adsorbed hydrated cations participated in ion exchange with the expansive soil, leading to the modification effect on its swelling potential. Meanwhile, the adsorbed water membrane surrounding the expansive soil aggregates formed by the hydrated cations obstructed further adsorption of water molecules, which inhibited the swelling development of expansive soil. Therefore, the swelling inhibition mechanism can be attributed to three factors: (i) modification effect, (ii) electrical environment, and (iii) deadweight of the CNS layer. The combined contribution of modification effect and electrical environment can be considered as an electric charge effect, which mainly controls the swelling characteristics of expansive soil.     

超深溜井爆破一次成井技术实践

为解决溜井掘进效率低、安全性差等问题，以柿竹园多金属矿掘进出矿溜井为例，提出了爆破一次成井技术，根据矿山具体爆破条件，设计了布孔参数、装药结构和起爆顺序等。实践表明，爆破一次成井技术施工天井效果良好，溜井贯穿上下2个分段，与设计相符，相较于普通法施工天井，节约成本30.7%，节约时间58.3%，经济效益显著，施工周期短，且安全性好，值得在其他类似矿山推广应用。     

An experimental investigation of refrigerant mixture R32/R290 as drop-in replacement for HFC410A in household air conditioners

In the present paper, the refrigerant mixture R32/R290 (68%/32% by weight) is investigated as the drop-in replacement for R410A in household air conditioners. The GWP of it is only 22% of that of R410A. Theoretical and experimental investigations are conducted on the performance of the air conditioners working with both R32/R290 and R410A. Experimental results show that the refrigerant charge amount of R32/R290 is reduced by 30.0%–35.0%; the cooling and heating capacities are increased by 14.0%–23.7%. For further reducing charge amount and flammability, the micro-channel heat exchanger (condenser) is employed to replace the finned tube one. Compared with the R32/R290 system using finned tube heat exchanger, the R32/R290 charge amount and the power consumption are reduced by 34.1% and 0.4%, respectively; the cooling capacity and the COP are increased by 6.4% and 6.8%, respectively.     

Space charge region effects in bidirectional illuminated P3HT:PCBM bulk heterojunction photodetectors

Organic semiconductors are widely investigated for their application in photovoltaics and photodetectors. We show that the efficiency of these devices is strongly influenced by the position of the space charge region, due to unintentional doping, and wavelength-dependent absorption properties in bulk heterojunctions. Spray-coated P3HT:PCBM bulk heterojunction photodiodes with thicknesses up to 4.2 μm and semitransparent top contact enable the characterization of exciton generation and separation in both irradiation directions. A large difference in external quantum efficiency (EQE) is observed for top and bottom illuminated configurations and is explained by a bias dependent arrangement of the space charge region at the two contact electrodes. Numerical drift–diffusion simulations allow to get insight into first order mechanisms behind the spectral features of EQE data in highly-doped organic photodiodes.     

Electrical Breakdown Properties and Space Charge Formation in High Temperature Region in Ultraviolet Ray Irradiated PVC

Polyvinyl chloride (PVC) is the most popular insulating material for electric wiring instruments. However, an exothermic reaction above 150 °C may cause deterioration of the insulating properties of PVC. Therefore, it is important to clarify the heat degradation in PVC, not only to investigate the ignition of electrical wiring products but also to use electrical products safely. It is known that ultraviolet (UV) irradiation causes chemical deterioration of PVC and an increase in its conductivity. Generally, it has been thought that the electrical breakdown properties, electrical conduction, and insulating performance are affected by space charge accumulation in an insulating material. A high temperature pulsed electroacoustic (PEA) system usable up to 250 °C has been developed, and the PEA system can measure the space charge distribution and conduction current in the high temperature range simultaneously. In this investigation, the space charge distribution and conduction current were measured up to electrical breakdown in a non‐UV irradiated sample (normal PVC) and in 353 nm and 253 nm UV‐irradiated PVC samples in the range from room temperature to 200 °C in a DC electric field. In the short wavelength UV irradiated PVC sample (253 nm, 300 h), a deterioration of breakdown strength at 90 °C to 150 °C and negative packet‐like charges were observed at 60 °C and 100 °C, a positive charge accumulated in front of both the anode and cathode above 90 °C, and a higher electric field near the cathode side because the positive charge of the cathode side was greater.     

A multiagent‐based microgrid operation method considering charging and discharging strategies of electric vehicles

In this paper, we propose a multiagent‐based microgrid (MG) operation method considering charging and discharging electric vehicles (EVs). The proposed system consists of five types of agents: single microgrid controller agent, several load agents, several gas turbines/engine agents, several photovoltaic generation agents, and several electric vehicle agents. In the proposed method, the load balancing can be realized by suppressing sudden fluctuations in supply and demand balance due to the synchronization of charging and discharging of EVs. From the simulation results, it can be seen that the proposed multiagent system could realize the load equalization in MG.